Removal and Installation Procedures
6-54
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
T-15 Torx
screw (7)
5/16 Nut
post (2)
3/16 Nut
post (2)
PPC
Processor
board
Figure 6- 35: PPC Processor board removal
CAUTION. Removing the Bridge board without first removing the PPC board will
damage the connector.
g. Grasp the Bridge board and pull it straight up to disconnect J870 edge
card connector from the PPC board. Remove the Bridge board from the
PPC board assembly. See Figure 6--36, page 6--55.
To Next Page
Loading...
