Tektronix CSA7404B - Page 278

Removal and Installation Procedures
6-58
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
c. Remove the three T-15 Torxdrive screws securing the Acquisition board
to the Front Panel Combination assembly.
T-15 Torx
screw (3)
Nut and washer
Cables (3)
TekConnect
ribbon cable
Figure 6- 38: Front panel combination assem bly removal
5. Remove the TekConnect circuit board: See Figure 6--39, page 6--59. Remove
the five T-15 Torxdrive screws securing the TekConnect board to the
combination assembly.
6. Remove a TekConnect bucket: See Figure 6--39, page 6--59. Remove the
three T-15 Torxdrive screws securing the TekConnect bucket to the Front
Panel Combination assembly.