Tektronix CSA7404B - Page 281

Removal and Installation Procedures
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
6-61
e. Carefully separate the Acquisition board from the combination assembly
chassis at the front corners of the Acquisition board.
5. Remove the TekConnect circuit board: See Figure 6--42, page 6--64. Remove
the five T-15 Torxdrive screws securing the TekConnect board to the
combination assembly.
6. Remove a TekConnect bucket: See Figure 6--42, page 6--64. Remove the
three T-15 Torxdrive screws securing the TekConnect bucket to the Front
Panel Combination assembly.