HD3G7 3 Gb/s SDI Video Generator module remote commands
:DIAGnostic:K
EYBoard[:TEST]?
Initiates a front panel k eyboard test and returns PASS or FAIL as appropriate.
This command r
equires front panel interaction by the user to complete the test.
:DIAGnostic:LOCK?
Returns the status of the JIT, FLEX0, and FLEX1 circuits where 0 indicates
locked and 1 indicates unlocked.
:DIAGnostic:PLL[:STATE]?
Returns the current PLL lock status for each of the three clocks: 12.288:<st>
54:<st> 74.25: <st> 74.176:<st> where st can be
lk for lock or un for unlock.
:DIAGnostic:POWer?
Returns a string with eight supply voltage values.
:DIAGnostic:TEMPerature?
Return
s the current temperature of the circuit board or FPGA in degrees
Celsius.
:DIAG
nostic:YCRC?
Returns the number of input Y CRC errors since clear.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 125
To Next Page
Loading...
Need help?
General
