TG8000 remote commands
*SRE?
Returns the contents of SRER.
*STB?
Returns the value of the SBR (Status Byte Register). Bit 6 of the SBR is read
as a MSS (Master Status Summary) bit.
*TST?
Self-test query. This query does not perform any tests; however, this query is
accepted as a valid command to comply with IEEE 488.2 requirements.
*WAI
Wait-to-continue command. This command is not necessary since the TG8000
handles commands sequentially; however, this query is accepted as a valid
command to comply with IEEE 488.2 requirements.
Calibration commands
Use these commands to perform calibration on the mainframe.
Command tree
:CALibration
:FREQuency
:CALibration:FREQuency
NOTE. AGL7 or GPS7 must be installed for this command to function properly.
Refer to the User Manual for calibration instructions.
Initiates frequency c alibration or query current frequency calibration v alue.
DISPLAY commands
Use these commands to control the contrast and backlight settings of the LCD
display.
Command tree
:DISPlay
:BACKlight ON | OFF
:CONTrast
<numeric_value>
[:WINDow][:TEXT][:D ATA]
<message>
Draft
16 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
