GPS7 GPS Synchronization and Timecode module remote commands
GPS7 GPS Synch
ronization and Timecode module remote
commands
This section describes the remote commands used to control the GPS7 GPS
Synchronization and Timecode module remotely. The commands to the module
are divided
into the following groups:
INPUT commands
SOURCE commands
OUTPUT commands
SENSE commands
CONFIGURE commands
NOTE. Commands which control generator lock (Genlock) features are not
supported by GPS7 modules that do not have a REF IN connector.
INPUT commands
Use these commands to control the input parameters of the module.
Command tree
:INPut
:STAtus
:REF
GPS | INTERNAL | NTSC Burst
| SMP TE318M | PAL Burst |
1080 60i | 1080 59i | 1 080
50i | 1080 23sF | 1080 24sF
| 108 0 30p | 1080 29p |
1080 25p | 1080 24p | 1 080
23p|72050p|72060p|
720 59p
:FOM
No Si gnal | Bad Signal |
Locked
:TOD YYYY-MM-DD HH:MM:SS
:UTC YYYY-MM-DD HH:MM:SS
:PCOUnter YYYY-MM-DD HH:MM:SS
:SIG
<numeric_value>
:SAT
<NR1>/<NR1>
:ANTenna
POWER OFF | OPEN | SHORT |
NOMINAL
:DIAG
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 77
To Next Page
Loading...
Need help?
General
