GPS7 GPS Synchronization and Timecode module remote commands
:INPut:SWARni
ng:THREshold
Sets the Figure of Merit (quality of GPS signal) value that triggers warning
indicators. Threshold can be set to integer values, from 1 to 11.
:INPut:SWARning:THREshold
Returns the Figure of Merit value that triggers warning indicators.
:ANTenna:POWer
Sets the power level supplied to the antenna.
:ANTenna:POWer?
Returns the antenna power setting.
:ANTenna:POSition FIXED | MOBILE
Sets the GPS module configuration that optimizes the system for either fixed
position or mobile (remote van) operation.
:ANTenna:POSition?
Returns the antenna position setting.
:GPS:ACQuire
Forces manual position acquisition. This is a set only command.
SOURCE commands
Use these commands to control the source parameters of the module.
Command tree
:SOURce
:CORRection
:MDELay
:HORizontal
<NRf>
:STEP
<NRf>|MIN|MAX|DEF
:VERTical
<NR1>
:STEP
<NR1>
:TIMESet
:OFFSet HH:MM,HH:MM
:OFFSet?
HH:MM,HH:MM
:TOD
:SOURce
GPS|INTernal | VITc | LTC
:SOURce?
GPS |I NTernal | VITc | LTC
:TIME HH:MM:SS
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 81
To Next Page
Loading...
Need help?
General
