Tektronix TG8000

TG8000 remote commands
Holds off furth
er commands until the specified sequence completes.
:PROGram:EXPLicit:WAIT? <pro gname>
If se quence has terminated or p aused, this returns 1. If sequence is running,
this returns 0.
SENSE commands
Use these queries to list which generator modules are using which frame reset
signals.
Command tree
:SENSe
:ROSCillator
:FRAMe[3]
:CATalog?
:FREQuency?
Command d escription
:SENSe:ROSCillator:FRAMe< n>:CATalog
Lists the modules using the frame reset signal <n>. The suffix identifies which
of three frame reset signals to query.
:SENSe:ROSCillator:FRAMe< n>:FREQuency
Lists the specific frame reset signal frequency.
STATUS commands
Use these commands to address the instrument status and event queue.
Command tree
:STATus
:OPERation
[:EVENt]?
:CONDition?
:ENABle <numeric_value>
:PTRansition <numeric_value>
:NTRansition
<numeric_value>
:MAP
<numeric_value>,
<numeric_value>
:INSTrument
Draft
22 TG8000 Multiformat Test Signal Generator Programmer Manual