AGL7 Analog Genlock module remote commands
Returns the ste
p increment used by the UP or DOWN command.
OUTPUT commands
Use these com
mands to set the video standard and the type of signal for the
BLACK outputs.
Command tree
:OUTPut1
:STANdard NTSC|PAL|NTSC_NSU
:OUTPut2
:STANdard NTSC | PAL | NTSC_NS |
HDSYnc
:OUTPut3
:STANdard BB | HD1080_60I |
HD1080_59I | HD 1080_50I
| HD1080_24SF | HD1080_30P
| HD10 80_29P | HD1080_25P
|HD1080_24P | H D1080_23P
| HD72 0_60P | HD720_59P |
HD720_50P
:OUTPUT<n>
:SIGNal BB | BB_FREF | BB_NO_FREE
Command description
:OUTPut1:STANdard NTSC|PAL|NT SC_NSU
Sets the video standard for the BLACK 1 output. The choices are NTSC,
PAL, and NTSC_NSU (NTSC no setup).
:OUTPut1:STANdard?
Returns the video standard for the BLACK 1 output.
:OUTPut2:STANdard NTSC|PAL|NT SC_NSU|HDSYnc
Sets the video standard for the BLACK 2 output. The choices are NTSC,
PAL, NTSC_NSU (NTSC no setup), and HDSYnc (HDTV trilevel sync).
:OUTPut2:STANdard?
Returns the video standard for the BLACK 2 output.
:OUTPut3:STANdard
BB|HD1080_60I|HD1080_59I|H D1080_50I|
HD1080_24SF|HD1080_30P|HD1 080_29P|
HD1080_25P|HD1080_24P|HD10 80_23P|
HD720_60P|HD720_59P|HD720_ 50P
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 35
To Next Page
Loading...
Need help?
General
