TG8000 remote commands
TG8000 remote
commands
This section
describes the remote command set used in the TG8000. The
commands for the TG8000 are divided into the following eight groups:
Common comm
ands
DIAGNOSTIC commands
DISPLAY commands
INSTRUMENT commands
MASS MEMORY commands
PROGRAM commands
SENSE co
mmands
STATUS commands
SYSTEM commands
The TG8000 can be controlled remotely through the Ethernet interface on the
rear panel. Refer to the TG8000 TV Signal Generator User Manual, Tektronix
part number 071-3036-XX, for detailed information about how to connect and
set u
p for remote operation.
Common commands
The
Common commands have a "*" prefix and address all of the installed modules.
Command tree
*CLS
*ESE()
*ESR
*I
DN
*OPC()
*OPT
*RST
*SRE()
*STB
*TST
*WAI
Draft
14 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
