Tektronix TG8000

TG8000 syntax
Signal names cr
eated from SDP2000 software will be displayed as created. Signals
created or displayed using the SCPI interface use the remote control sequence.
For example: "
SinX/X" is displayed as "SinX/X" via the front panel or
SDP2000 software; however, "SinX/X" is displayed as "SinX‘sX" via when
using SCPI.
Use the caret symbol "^" as a line return when naming buttons and signals.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 13