SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
SDI7 Dual Chan
nel SD/HD/3G SDI Video Generator module
remote commands
This section describes the commands used to remotely control the SDI7 Dual
Channel SD/HD/3G SDI Video Generator module. The commands are divided
into the fol
lowing groups:
OUTPUT commands (Refer to the SDI7 section of the TG8000 User Manual,
Tektronix
part number 071-3036-XX, for restrictions on which standards
are supported for each output mode.)
SENSE com
mands
OUTPUT commands
Use thes
e commands control the output parameters of the module.
Command tree
:OUTPu
t<1|2>
:ALPHa
COPY_YG | FF_0P | FF_10P |
FF_20P | FF_30P | FF_40P |
FF_50P | FF_60P | FF_70P |
FF_80P | FF_90P | FF_100P
:ALPHa?
:ANC
:OUTMode DIS | CONT | SING
:OUTMode?
:PARIty
MAN | AUTO
:PARIty?
:L
INe
<N
R1>,<NR1>
:LINe?
:SAMple
<NR1>
:SAMple?
:DID
<Hexadecimal>
:DID?
:SDID
<Hexadecimal>
:SDID?
:DBN
<Hexadecimal>
:DBN
:DC <NR1>
:DC
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 147
To Next Page
Loading...
Need help?
General
