Tektronix TG8000 Programmer's Manual

TG8000 remote commands
Command description
*CLS
Clears SESR (Standard Event Status Register), the SBR (Status Byte
Register), and Event Queue, which are us ed in the instrument status and event
reporting system.
*ESE
Sets the bits of the ESER (Event Status Enable Register) used in the status
and events reporting system.
*ESE?
Returns the contents of the ESER.
*ESR?
Returns the contents of SESR (Standard Event Status Register) used in the
status and events reporting system.
*IDN?
Returns the ID information of the instrument. Query only command returns
"TEKTRONIX,TG8000,0,0".
*OPC
Causes bit 0 in the SESR (Standard Event Status Register) to be set, and
the operation complete message to be issued, when all pending operations
are finished.
*OPC?
Waits until all pending operations are finished and returns a "1 " ASCII
character.
*OPT?
Lists all of the occupied slots in the TG8000 and the nomenclature, slot,
hardware version, and software version of the installed modules.
Each field is a slot. Each fi eld is separated by commas. The information
within a field is colon delimited, as in “
<CPU version>, <Frame
FPGA>,<Front Panel version>,<SW ve rsion>, <compilation
date>;<module name>[slot>];< hardware version><hardware
version string (often contains versio ns for additional
FPGAs)>;<software version><s oftware date string>”,<repeat
for additional slots>”
.
*RST
Resets the instrument to the default state.
*SRE
Sets the bits of the SRER (Service Request Enable Register).
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 15

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English