Tektronix TG8000

HDVG7 HDTV Digital Video Generator module remote commands
Returns the cur
rent Y component output state of the serial digital video
signals.
:OUTPut1:VID
eo:PB:STATe ON|OFF
Turns the P
B
component of the serial digital video signals on or off. You can
also use 1 or
0 instead of ON or OFF.
:OUTPut1:VIDeo:PB:STATe?
Returns the current P
B
component output state of the serial digital video
signals.
:OUTPut1:VIDeo:PR:STATe ON|OF F
Turns the P
R
component of the serial digital video signals on or off. You can
also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:PR:STATe?
Returns the current output state of the P
R
component of the serial digital video
signals.
:OUTPut1:VIDeo:AVTiming:ST ATe ON|OFF
Turns the output mode for an audio/video timing measurement on or
off. Refer to Operating Basics in the TG8000 User Manual for detailed
information about the mode. You can also use 1 or 0 instead of ON or OFF.
:OUTPut1:VIDeo:AVTiming:ST ATe?
Returns the current output mode setting for an audio/video timing
measurement.
:OUTPut2:STANdard
HD1080_60I|HD1080_59I|HD10 80_50I|HD1080_24SF|
HD1080_23SF|HD1080_30P|HD1 080_29P|HD1080_25P|
HD1080_24P|HD1080_23P|HD10 35_60I|HD1035_59I|
HD720_60P|HD720_59P|HD720P _50P|HD720_30P|
H
D720_29P|HD720_25P|HD720_24P |HD720_23P
Sets the video standard for the serial digital black signals output from the
BLACK connectors. The choices are HD 1080_60I to HD720_23P. This
command is only available if Option BK is installed.
:OUTPut<n>:STANdard?
Returns the video standard for the selected output. The <n> in the command
represents the output connector type. "1" represents the SIGNAL connectors
and "2" represents the optional BLACK connectors.
:OUTPut2:SIGNal BLACk|GRAY|FF 50P|WHITe
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 143