Tektronix TG8000

List of Figures
Figure 1: Command parts.......................................................................................... 1
Figure 2: 10/100/1000 Base-T connector is on the left side of the rear panel ............................... 2
Figure 3: Example of SCPI subsystem hierarchy tree.......................................................... 7
Figure 4: Ex
ample of abbreviating a command................................................................. 9
Figure 5: Example of chaining commands and queries ........................................................ 9
Figure 6: Example of omitting root and lower-level nodes in a chained message ............. ............ 10
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual iii