Tektronix TG8000

GPS7 GPS Synchronization and Timecode module remote commands
:TIME
<numeric_value>,<nu meric_value> ,
<numeric_value>
:TIMe?
:LLOSs
:GPO
:MDELay
<Nr1>,<Nr1>,<Nr1>
(HH:MM:SS)
:MDELay
:BLAck
:MDELay
<Nr1>,<Nr1>,<Nr1>
(HH:MM:SS)
:MDELay?
:NLLOS
s
:GPO
:MDELay
<Nr1>,<Nr1>,<Nr1>
(HH:MM:SS)
:MDELay?
:NOG
L
:GPO
:MDELay
<Nr1>,<Nr1>,<Nr1>
(HH:MM:SS)
:MDELay?
:SWARning
:GPO
MDELay
<numeric_value>,<nu meric_value> ,
<numeric_value>
MDELay?
:GPIo
:INPut
RESET_COUNT | R EACQ_SAT |
JAM
:INPut?
:OUTPut[1/2] NONE | SIG_WARN |
LOCK_LOSS | ALA RM_TIME
| NEAR _LLOS | NO_GENLOCK
:OUTPut[1/2]?
:STATus
String
(OUTPUT2,OUTPUT1,IN PUT)>
:== "0,0,0", ."1,1,1"
Command description
:SOURce:CORRection:MDELay: HORizontal <NR1>
Sets the horizontal timing offset o f the selected source. The timing resolution
is clock-cycles. T he units are microseconds. See Table 2-3 for the delay
ranges.
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 83