Telkom OPTICON MICRO - DND (Do Not Disturb) and Headset; Directory Feature Conditions; DND Feature Description; DND Feature Operation

OptiCon Micro
Installation and Operation Manual
21
2.7 Hardware Initialization
2.7.1 LWS-BS and LWS-WK
Once the LWS-BS and the LWS-WK have been properly installed in the desired location, perform
the following:
1. Plug in the AC/DC adapter to the LWS-BS or the LWS-WK (use only the included AC/DC
adapter, SA-B122).
2. The LWS-BS or the LWS-WK is powered up and its display on the LCD will be activated.
3. Register the LWS-WK to the LWS-BS, see section 2.12.
Note: The LWS-BS requires one minute to become fully functional after power on.
2.7.2 Wireless Handset
To start up the Handset:
1. Press and hold [ ] for approximately 2 seconds.
2. The handset automatically enters standby mode when a signal is located.
3. The handset automatically returns to standby mode whenever it is placed on the charger.
4. Register the Wireless Handset to the LWS-BS, see section 2.12.
To power-down the Handset:
1. Press and hold [ ] for approximately 3 seconds
2.8 Display
2.8.1 LCD Specification
Users can select one of the backlight control options (always on, always off, on when busy).
2.8.1.1 LWS-BS
 240 x 144 Graphic LCD
 Backlit On/Off Control with 3 selectable option
 Ten-Level Contrast Setting
2.8.1.2 LWS-WK
 240 x 42 Graphic LCD
 Backlight On/Off Control
 Ten-Level Contrast Setting