2.12 Terminal Registration and Termination
The LWS-BS controls the functional service and registration of the LWS-WK and GDC-400H/450H. First
of all, they should be subscribed to LWS-BS before used.
2.12.1 Subscribing the GDC-400/450H / LWS-WK to LWS-BS
Only one Wireless Handset or Keyset can be registered at a time.
2.12.1.1 Enabling Subscriptions
To enable registration of terminal the below procedure should be performed on the LWS-BS.
1. Press t he [Menu] button.
2. Press [Digit 1] (CONFIGURATION submenu), or
Select [1. CONFIGURATION] using the Navigation up/down key and then press t h e [OK]
soft button or Navigation „OK‟ key.
3. Press [Digit 4] (STATION REGISTER submenu), or Select [4. STATION REGISTER] using
the Navigation up/down key and then press t h e [OK] soft button or „OK‟ key of the
Navigation.
4. Press [Digit 1] (REGISTER submenu), or Select [1. REGISTER] using the Navigation
up/down key and then press [OK] soft button or Navigation „OK‟ key.
5. Select the phone type using the Navigation left/right key (GDC-4XX or LWS-WK)
6. Press t h e [OK] soft button or Navigation „OK‟ key.
7. Wait for completing the subscription.
8. When the subscription is completed, the below message is shown on the LCD of the
LWS- BS.
STATION: 10X
SUBSCRIBED: SUCCESS
2.12.1.2 Subscribing GDC-400H/450H to the LWS-BS
To subscribe to the LWS-BS, below procedure should be performed on the GDC-400H/450H.
1. Press [Menu] ( , ) button to display the menu.
2. Highlight [Phone Register] the menu using the Navigation ( ) button.
3. Press [OK] ( , ) button; and then the Phone Register menu will display.
4. Select [LWS Subscription] using the up and down arrows of the Navigation ( )
button and press [OK] (
, ) button.
5. Display [Searching.1].
6. The system [ RFPI (PARK): e.g. 01234567890123] will display when a system is found.
The RFPI (PARK) of your system is available from your System Administrator or the
attendant.
7. Press [OK] ( , ) button; in a few second, a confirmation tone will be heard at the
GDC-400H/450H.
8. If the subscription fails, repeat the procedure from Step 1 to 7 at the LWS-BS and Step 1 to 7 from
the GDC-400H/450H.
To Next Page
Loading...
