OptiCon Micro
Installation and Operation Manual
37
3.4 Call Waiting/Camp-On
Description
Call Waiting is used to notify a busy station that a call is waiting. The busy station is notified of the
waiting call with a Camp-On tone. After receiving a busy signal, the calling station camps on to the called
station. The called station can respond by:
answering the waiting call, which places the active call on hold,
activating One-Time DND, or ignoring the Camp-On tone.
Operation
To activate a Camp-On while receiving the Intercom busy tone:
1. Press the „*‟ button, called and calling stations receive Camp-On tone.
Conditions
1. The user may only Camp-On to a station in busy mode; a user may not Camp-On to a station in
DND, conference, etc.
2. If the calling station disconnects from the call after activating Camp-On, Camp-On is cancelled.
3. A Camp-On tone is sent each time the calling user presses the „*‟ button.
3.5 LINE Access
Description
Stations can access outgoing lines. The LWS-BS station and LWS-WK may use flexible buttons assigned
to access a specific line button for outgoing calls.
Operation
To place an outgoing Line call:
LWS-BS station and LWS-WK
1. Lift the handset or press the [Speaker] button.
2. Press desired {LINE} button, dial the {line access} code (0 or 8801 ~ 8803).
GDC-400H/450H
1. Press ([Talk] key).
2. Dial the {Line access} code (0 or 8801 ~ 8803).
To answer an incoming Line call:
LWS-BS station
1. Lift the handset or press the [Speaker] button. Or,
2. Press flashing {LINE} and lift the handset to speak privately.
LWS-WK
1. Lift the handset or press the [Speaker] button.
2. In LWS-WK, it isn‟t supported to answer the incoming call by pressing {Line}/{Station} button in
ringing state.
GDC-400H/450H
1. Press ([Talk] key).
To Next Page
Loading...