Telkom OPTICON MICRO - Call Barring and Music-On-Hold; Allow;Deny Number Description; Call Barring Programming

OptiCon Micro
Installation and Operation Manual
27
2.11 Configuration
2.11.1 Nation code
To set the nation code on the LWS-BS, perform the following:
1. Press the [Menu] button on the LWS-BS.
2. Select 1. CONFIGURATION > 2. COUNTRY.
3. If you want to change the country, press the [CHANGE] soft key or the [OK] Navigation key.
4. Set the Nation code. *27 for Telkom.
5. When finished, press the [SAVE] button, and system will ask you to confirm it.
6. If you select [YES] by pressing digit 1, the system will restart and the database will be initialized.
2.11.2 LWS-BS Date and Time
The Date and Time of the LWS-BS can be set and adjusted by the user after configuring the Location
(Nation code set, recommended). In the event of a power failure, the system will retain Date and Time
stored in database with internal Lithium Battery. All terminals registered to the LWS-BS will
automatically take the Date and Time information of the LWS-BS after pressing Talk key or Speaker
button.
To set the Date & Time:
1. With the LWS-BS in idle state, press the [Menu] button.
2. Select 1. CONFIGURATION > 1. DATE / TIME.
3. In this menu, set the Date and Time by entering the desired values using the keypad and
scrolling with the navigation arrow keys.
4. When finished, press the [SAVE] soft key or press the [OK] Navigation key and a
confirmation tone will be heard.
Note:
 Date and Time of Wireless KTU will be updated by the LWS-BS after pressing Talk key or
Speaker button.
2.11.3 GDC-400H/450H Handset Time
To set the GDC-400H/450H Wireless Handset Time:
1. Press [MENU].
2. Select [Phone Settings] > [Clock].
3. Enter the [DD.MM.YY] and hours and minutes using 4 digits (ex., 0 7 3 5 for 07:35).
Note:
 Date and Time of GDC-400H/450H and Wireless KTU will be updated by the LWS-BS
after pressing Talk key (GDC-400H/450H) / pressing speaker button (Wireless KTU).