OptiCon Micro
Installation and Operation Manual
36
3. Dial the telephone number to receive the transfer.
4. When answered, announce the call.
5. Press the ([End] key]) to complete the transfer.
While on a call, to perform an Unscreened Call Transfer:
LWS-BS station and LWS-WK
1. Press the [Trans] button.
2. Dial the station to receive the transfer.
3. Hang-up to complete the transfer.
To transfer a call to an external destination when “OFFNET FORWARD/TRANSFER” (Menu 1 5 3) is set to
“ENABLE”,
1. Press the [Trans] button.
2. Press desired {LINE} button.
3. Dial the telephone number to receive the transfer.
4. Hang-up to complete the transfer.
GDC-400H/450H
1. Press the ([Navigation right] key) shorter than 1 second.
2. Dial the station to receive the transfer.
3. Press the ([End] key]) to complete the transfer.
To transfer a call to an external destination when “OFFNET FORWARD/TRANSFER” (Menu 1 5 3) is set to
“ENABLE”,
1. Press the ([Navigation right] key) shorter than 1 second.
2. Dial the Line access code.
3. Dial the telephone number to receive the transfer.
4. Press the ([End] key]) to complete the transfer.
Conditions
1. The transferring station may camp a call to a busy station (refer to Camp-On).
2. A station in DND, out of range or out-of-service cannot receive a transfer; any attempt will result in
an error tone.
3. If an external call is transferred to external destination (Line to line call), the call duration will be
limited to the “Line to Line call timer”(Menu 3 4 9)
4. Calls transferred Off-Net are subject to restriction (Menu 1 5 1). The exception is calls transferred
to speed dial numbers (200~399).
Programming
CONFIGURATION Offnet forward/transfer – [Menu] + 1 5 3
SUPPLEMENTARY Line to Line call timer – [Menu] + 3 4 9
To Next Page
Loading...