WAN
43
IPv6 WAN settings
You can configure the WAN IPv6 address information in this part.
When IP Protocol is set to IPv6 or IPv4/IPv6, and Channel Mode is set to IPoE or PPPoE, these
parameters are required.
Parameter description
It specifies how the WAN IPv6 address of the ONT is obtained, including:
⚫
Slaac: Stateless Address Autoconfiguration (SLAAC) is a dynamic allocation method of
IPv6 address, which enables the ONT to auto-generate IPv6 addresses with local
information and those from the router advertisement.
⚫
Static: You need to enter parameters related to IPv6 address manually.
It specifies the IPv6 address and prefix length provided by your ISP when you select
Static for Address Mode.
It specifies the IPv6 gateway address of the ONT when you select Static for Address
Mode.
It specifies whether the ONT acts as a client to receive configuration information from
the DHCPv6 server.
You can enable the ONT to obtain the IPv6 address and prefix as a DHCPv6 client when
Enable DHCPv6 Client is selected.
When Request DNS is set to Enable, the ONT obtains the IPv6 DNS server address from
the DHCPv6 server.
When Request DNS is set to Disable, you need to set the primary and secondary DNS
server addresses manually.
PPP settings
You can configure the PPPoE parameters to access the internet in this part.
When Channel Mode is set to PPPoE, these parameters are required.
To Next Page
Loading...
Need help?
General
