Tenda TEG3224P User Manual

User Guide
37
To config LACP parameters on a group of ports as a batch task: click Config as seen below:
Application Example of LACP
Configurable range of system priority is 0-65535 and the default is 32768. When system priority is set,
ports in LACP aggregation group with higher priority will be selected. The primary device of LACP
aggregation group is determined by priority+management MAC address. The primary port of LACP
aggregation group is determined by port LACP priority+port number. Application example is interpretated
as below:
Switch A
Switch B
2
3
4
1
Switch A Switch B
1) Create LACP aggregation group 5(ports 1-4 included) on switch A and switch B, and set port rate to
100M/FULL on port 1 and port 4.

Tenda TEG3224P Specifications

General

Brand	Tenda
Model	TEG3224P
Category	Switch
Language	English