User Guide
48
Note--------------------------------------------------------------------------------------------------------------------------------
1. An existing Trunk port cannot be directly configured as a Hybrid port. However, you can convert a
Trunk port into a Hybrid port by first deleting it from Trunk ports and then setting it to a Hybrid port.
2. Deleted hybrid ports will join VLAN1 as access ports.
3. A hybrid port can belong to multiple VLANs.
-------------------------------------------------------------------------------------------------------------------------------------------
Port VLAN
Port VLAN and 802.1Q VLAN can be toggled randomly. If you toggle 802.1Q VLAN to port VLAN, related
VLAN configurations will be cleared.
Create a port based VLAN
1. Toggle to the Port VLAN mode to enter the Port VLAN interface.
2. Click Port VLAN to enter below interface:
3. Click New as seen below:
4. Enter a VLAN ID: for example 2-24, which indicates 24 VLANs, or "1, 24", which indicates 2 VLANs.
5. Select port(s) from Available Ports and click to move them to Member Ports.
6. Click OK to finish.
Delete members in a port VLAN
As seen above, ports 1-2 are still in VLAN1. To isolate them from other ports, do as follows:
1. Click VLAN1 as seen below.
To Next Page
Loading...
Need help?
General
