Tenda TEG3224P - 4.4 PoE Management

User Guide
53
letters (case-sensitive), numbers and underlines can be configured here.
3. Enter the specific protocol Ether Type (0x600-0xFFFF). The corresponding relationship between
Ether Type and protocol name is shown as below:
Ether Type
Corresponding Protocol
Name
0x0806
ARP
0x0800
IP
0x8847/0x8848
MPLS
0x8137
IPX
0x8000
IS-IS
0x8809
LACP
0x888E
802.1x
4. Configure protocol model's Frame Type. It can be configured as EthernetII, LLC and SNAP.
5. Click OK.
Note--------------------------------------------------------------------------------------------------------------------------------
1. It is not advisable to add special type into the protocol model, such as 0X8100 and 0x88a8.
2. EthernetII: Protocol VLAN matches with 13~14th bytes to map VLAN; LLC: Protocol VLAN matches
with 17~18th bytes to map VLAN; SNAP: Protocol VLAN matches with 23~24th bytes to map VLAN
and 16~21th bytes are AA-AA-03-00-00-00.
-------------------------------------------------------------------------------------------------------------------------------------------
 Delete protocol model
Click the Delete button to delete the corresponding protocol model. If the protocol moel has been applied
in protocol VLAN, this protocol model can’t be deleted.
Protocol VLAN---Config
Click VLAN Management -> Protocol VLAN ->Protocol VLAN to enter interface below: