Configures PoE power management mode.
When it is static, you can configure power allocation
manually. When power supply is connected on the
port, part of power will be enforced to be reserved
for this port and can't be used by other ports.
When it is dynamic, according to actual used power
allocation, in full load, power will be allocated by
port priority (priority + port number). If the priority is
the same, the smaller the port number is, the higher
the priority.
4.4.2 Port Setup
Click PoE Management -> Port Setup to enter interface below:
Fields on the screen are described below:
To Next Page
Loading...
Need help?
General
