User Guide
142
3. Specify a Max Packet Size value, the default is 1500.
4. Configure contact info. The default is www.Tendacn.com.
5. Here you can specify device's physical location.
6. SNMP Version: Select V1, V2c or V3.
7. Click Add to create a community name as seen below:
Note: You must create a view before you can create a community.
8. Community Name: Click Standard and select public or private; click Custom and enter a
community name of up to 31 characters.
9. Access Right: Select Read only or Read & Write.
10. Click OK.
Now you can use the V1, or V2c community name to view or config settings of nodes in the MIB.
User
To enter the screen below, click Device Management -> SNMP -> User.
This section displays information of added user(s).
Click Add to enter interface below:
To Next Page
Loading...
