User Guide
151
2. Specify the server ID (1-4).
3. Specify the IP address, say 1.1.1.10.
4. Click OK.
Then continue to create remote DHCP server 2 as the same steps listed above.
Note--------------------------------------------------------------------------------------------------------------------------------
1. The remote server must be in the same network segment with one of the virtual interfaces.
2. Virtual interfaces on which DHCP relay has been enabled can’t select remote servers which are in
the same network segment with virtual interfaces themselves.
3. Remote servers applied for DHCP relay can’t be deleted.
-------------------------------------------------------------------------------------------------------------------------------------------
DHCP Relay Setup
1. Click Device Management -> DHCP Relay -> DHCP Relay Setup to enter interface below:
To Next Page
Loading...
