November 2008 Section 4 - Maintenance Procedures
TABLE A
Document 57.0009.0427
7
GTH-4017EX GTH-4514EX GTH-4013EX
A-5 INSPECT THE OPERATOR’S MANUAL
Maintaining the operator manual in good condition is
essential to consult it if necessary..
Manual are included with each machine and should be
stored in the cab. An illegible or missing manual will not
provide safety and operational information necessary for
a safe operating condition.
In particular:
- check to be sure the storage container is in good
condition.
- check to make sure that the operator manual are
present, complete and in the storage container in
the cab.
- examine the pages of each manual to be sure that
they are legible and in good condition.
- always return the manual to the storage container
after use.
NOTICE
Contact GENIE Service Centre if replacement manuals
are needed.
A-6 INSPECT THE DECALS AND PLATES
Maintaining all of safety and instructional decals and
placards in good condition is mandatory for safe machine
operation. Decals alert operators and personnel to
the many possible hazards associated with using this
machine.
An illegible decal will fair to alert personnel of a procedure or
hazard and could result in unsafe operating conditions.
- refer to the “labels and warning plates applied on the
machine” section in the Operator Manual and use the
decal list and illustrations to determine that all decals
and placards are in place.
- inspect all decals for legibility and damage. Replace
any damaged or illegible decal immediately.
NOTICE
Contact GENIE Service Centre if replacement
decals are needed.
To Next Page
Loading...
Need help?
General
