Section 5 - Problems-Causes-Solutions November 2008
PROBLEMS-CAUSES-SOLUTIONS
Document 57.0009.0427
GTH-4017EX GTH-4514EX GTH-4013EX
2
5.2 ABOUT THIS SECTION
The tables on the following pages should be used to
find and rectify problems that can occur when using the
machine.
Prepare adequate tools, and especially a voltmeter and
a pressure gauge to carry out the checks explained on
next pages.
The initials of the electrical and hydraulic parts indicated in
the following tables are given to help you find such parts
on the schemes and diagrams in chapter 6.
The tables should be read as follows:
- once you have identified the problem, search this
problem in the "problems" column;
- analyse the possible causes explained in the "causes"
column;
- proceed with the check or replacement according to
the instructions provided in the "solutions" column;
- check that the machine runs well;
- if the problem cannot be eliminated, check again
all indications in the "causes" column and proceed
accordingly.
CAUTION
For any further information, contact the GENIE
Service Centre.
To Next Page
Loading...
