Terex Genie GTH-4017 EX - Change the Safety Element of Engine Air Filter; (Gth-4017 Ex - Gth-4514 Ex

Document 57.0009.0427
GTH-4017EX GTH-4514EX GTH-4013EX
52
Section 4 - Maintenance Procedures November 2008
TABLE D
4.7 TABLE E PROCEDURES
E-1 CHANGE THE SAFETY ELEMENT AIR FILTER
(GTH 4013EX)
To change the safety element:
- Stop the engine and engage the parking brake.
- Unlatch the four fasteners A.
- Remove cover B.
- Pull out the outer filter cartridge C.
- Pull out the inner filter cartridge D.
- Clean the filter bowl.
- Refit the clean cartridge D, or a new one, using
some grease on the seal and make sure it is properly
positioned.
- Refit the element C and the cover B.
WARNING
The inner element should be replaced every second
time the outer element is replaced.
WARNING
Do not wash the cartridge using water or other kind
of solvents.
A
B
C
D
CHANGE THE SAFETY ELEMENT AIR FILTER
(GTH 4017EX - GTH 4514EX)
To change the safety element:
- Stop the engine and engage the parking brake.
- Unscrew the four fixing scerws of the cover.
- Remove cover B.
- Pull out the outer filter cartridge C.
- Pull out the inner filter cartridge D.
- Clean the filter bowl.
- Refit the clean cartridge D, or a new one, using
some grease on the seal and make sure it is properly
positioned.
- Refit the element C and the cover B.
WARNING
The inner element should be replaced every second
time the outer element is replaced.
WARNING
Do not wash the cartridge using water or other kind
of solvents.
B
C
C