6. Apply the swing brake.
7.
Apply the swing lock.
8.
Apply the Service Brake.
9. Release the Parking Brake.
10. Push in the clutch (if equipped with a manual transmission).
11. Select the desired transmission range.
OFF-THE-ROAD OPERATION:Good judgement in the selection of gear range and route of
travel is essential when operating off the road. Holes and soft or spongy ground subject the
machine to excessive stresses and should be avoided.
HARD SURFACE OPERATION:When operating on highways, the machine is subjected to
the same regulations as which govern the operation of other heavy equipment on public
roads. Adequate lighting, flares, flags and safety equipment should be on the machine at all
times.
TIRE INFLATION:For maximum tire loading capacities, tire pressures should be maintained
as indicated in the following table.
The inflation pressures shown below are for those taken with the tires at the prevailing
atmospheric temperatures and do not include any inflation pressure build-up due to vehicle
operation.
TIRE DATA-T300-1 & T500-1 DUALS SINGLES-FRONT
Tire Size 11R22.5 14PR XDE 425/65R22.5, 20PR
Ply Rating 14 18
Pressure (PSI) 95 110
Pressure (kPa) 655 758
TIRE DATA-T780 DUALS SINGLES-FRONT
Tire Size 315/80R22.5 MICHELIN
TREAD XDY 3 (40302)
315/80R22.5 MICHELIN
TREAD XDY 3 (40302)
Ply Rating 20 20
Pressure (PSI) 120 max. 120 max.
Pressure (kPa) 830 830
Before stopping the engine, put the transmission in neutral, engage the parking brake and
reduce engine speed.
Always idle the engine for at least 5 minutes before stopping it. This give the engine a
chance to cool down and prevents overheating which can be caused by localized hot spots
in the engine. The idle speed must be high enough to charge the battery but not higher
than half speed.
219P/N 12261-683 REVISED: January 2015
To Next Page
Loading...
