TIRES
MAINTENANCE CHECK
As a part of the WEEKLY MAINTENANCE CHECK inspect the tires and rims for damage.
Cuts, bruises, snags, punctures, and abrasions should be repaired before they can cause
tire failure. Bent, cracked, or loose rims should be repaired or replaced.
Check tire valve condition and make sure each valve has a cap.
TIRE PRESSURES
Always maintain the recommended tire inflation pressures in all tires.
When driving, some increase in tire pressures can be expected due to heat generated by
friction. Overspeeds may also produce increased pressures. In such circumstances,
NEVER BLEED THE TIRES. Instead, slow down or stop until the tires cool.
The energy stored in a tire and rim assembly under pressure makes changing
truck and off-road tires hazardous. Special procedures must be followed and
special tools must be used if tires are to be changed safely. Whenever possible,
let your tire service company handle this job. If you must change a tire, follow the
step-by-step instructions detailed in a tire repair manual. Should low pressures
make it necessary to add air, never stand beside the tire. Instead, use an
extension hose long enough to permit you to stand behind the tire tread. Always
use a tire cage or equivalent protection when adding air.
T300-1_T500-1_T780
Maintenance
320 P/N 12261-683
REVISED: January 2015
To Next Page
Loading...
