Traveling around the Jobsite
When traveling around a job site, it is very important that the crane operator is
very aware of what is happening with the crane as well as with other vehicles and
personnel on the job site. The crane operator should observe the following rules
as well as good common sense while moving a crane around a job site.
NOTE: See the “ON TIRES LIFT” instructions found in the Operating Instructions
section for Information on moving the crane with a load.
- Carry the boom over the front only.
- Lock the swing brake and swing lock.
- Secure the hook block or ball to the bumper loop or raise the hook block or ball close to
the boom head sheaves before moving.
- Make sure all outriggers are completely retracted before moving the crane.
1. Outrigger Beam Lock Pin-Install as shown (4) places.
225P/N 12261-683 REVISED: January 2015
To Next Page
Loading...
