Machine Maintenance Checklist
DAILY CHECK (8 HOURS)
___ Perform Daily Lubrication ___ Check Boom Front Slider Pads
___ Check Hydraulic Reservoir Fluid
Level ___ Drain Air Tanks
___ Fill Fuel Tank ___ Check Wire Rope And Related Components
___ Check Engine Oil Level ___ Check Air Cleaner
___ Check Coolant Level ___ Check Controls
___ Check Hydraulic Cylinder
Mounting Bushings And Pins
___ Check Instruments, Gauges, Lights, & Safety
Equipment
___ Check Hydraulic Components &
Hoses (See Hydraulic Hose topic in
Maintenance section) ___ Make Overall Visual Inspection
___ Check Transmission Oil Level ___ Check Anti-Two Block System
___ Check Boom Chains And Ends
___ Check Engine Manufacturer’s Manual For
Additional Maintenance Requirements
___ Drain Fuel Filters or Water
Separator
___ Ensure Swing Brake Is Able To Hold Against
Full Torque of Swing Motor
___Check DEF (Urea) Fluid Level in
Reservoir ___Drain Water from Air Tanks
WEEKLY CHECK (40 HOURS)
___ Perform The Daily Check ___ Check Torque On Wheel Lug Nuts
___ Perform Weekly Lubrication ___ Check Hydraulic Cylinders and Rods
___ Check Swing Reducer Oil Level ___ Make Thorough Inspection Of Wire Rope
___ Check Axle Oil Level (after initial
change)
___ Visually Inspect All Structural Members And
Welds For Cracks, Alignment and Wear
___ Check Battery Condition
___ Check Boom For Wear, Cracked Welds, Align-
ment And Missing Or Illegible Decals
___ Check Tire Pressure and Condition
___ Check Engine Manufacturer’s Manual For Addi-
tional Maintenance Requirements
___ Check Air System Safety Valve
___ Clean Machine Weekly If Salt Covered To
Prevent Rust And Corrosion
MONTHLY CHECK (100 - 200 HOURS)
___ Perform Daily And Weekly Checks ___ Check All Slider Pads
___ Perform Monthly Lubrication ___ Have Hydraulic Oil Sample Analyzed
___ Check Engine Belts ___ Clean Radiator & Oil Cooler Exterior
T300-1_T500-1_T780
Maintenance
288 P/N 12261-683
REVISED: January 2015
To Next Page
Loading...
