Restoring Transmission to Service
1. If Nox Rust, or equivalent, was used in preparing the transmission for storage,
use the following procedures to restore the unit to service.
2. Remove the tape from openings and breather.
3. Wash off all the external grease with solvent.
4. Add hydraulic transmission fluid, per chart below to proper level.
5. If Nox Rust or equivalent, was not used in preparing the transmission for
storage, use the following procedures to restore the unit to service.
6. Remove the tape from openings and breathers.
7. Wash off all the external grease with solvent.
8. Drain oil.
9. Install a new oil filter element(s).
10. Refill transmission with hydraulic transmission fluid. See chart below
TRANSMISSION TYPE RECOMMENDED FLUID
1. ALLISON 3000 & 4000 Series Auto TES 295
2. EATON-FULLER MANUAL SAE 40 or SAE 50 (must meet CAT TO-4
requirement)
377P/N 12261-683 REVISED: January 2015
To Next Page
Loading...
