___ Check Hydraulic Reservoir For
Moisture
___ Check Engine Manufacturer’s Manual For
Additional Maintenance Requirements
___See Engine Maintenence Section ___See Transmission Maintenence Section
QUARTERLY CHECK (250 HOURS)
___ Perform Daily, Weekly And
Monthly Checks ___ Change Hydraulic Return Line Filters
___ Perform Quarterly Lubrication
___ Replenish Cooling System Corrosion Inhibitor
(refer to engine manufactures manual)
___ Drain Fuel Tank Of Water And
Sediment If Necessary
___ Check Engine Manufacturer’s Manual For
Additional Maintenance Requirements
___ Check Brake Shoes for Wear
Condition ___ Lubricate Valve Disconnects
___ Change Transmission Oil And
Shift Air Filter ___ Clean And Wax All Exterior Painted Surfaces
___See Engine Maintenence Section ___See Transmission Maintenence Section
SEMI - ANNUAL CHECK (1000 HOURS)
___ Perform Daily, Weekly, Monthly
And Quarterly Checks
___ Change Power Steering Filter Element-(T300-1
only)
___ Perform Semiannual Lubrication ___ Check Hydraulic Relief Valve Pressure Settings
___ Clean Crankcase Breather
___ Torque Swing Bearing Bolts T300-1 & T500-1
(725 ft. lbs.) , T780 (980 ft. lbs.) according to
tightening sequence.
___ Check Hydraulic Reservoir Relief
Valve
___ Check Engine Manufacturer’s Manual For
Additional Maintenance Requirements
___ Clean Hydraulic Reservoir Intake
Suction Filter
___ Check All Adjustments Specified In The “Service
And Adjustments” Section Of This Manual And Any
Vendor Manuals Supplied
___ Check Air Dryer Desiccant For
Signs Of Oil Accumulation ___See Engine Maintenence Section
___See Transmission Maintenence
Section
ANNUAL CHECK (1500 - 2000 HOURS)
___ Perform Daily,Weekly, Monthly,
Quarterly and Semi-annual Checks
___ Change Hydraulic Fluid (unless checked by oil
analysis).
___ Perform Annual Lubrication ___ Drain and Refill The Winch Lubricant
___ Disassemble Winch And Inspect. ___ Change Axle Oil
289P/N 12261-683 REVISED: January 2015
To Next Page
Loading...
