RT130 Load Drop Due to Temperature
4 Part of Line, 3 Different Boom Extensions, 60° Boom angle
Load Drop (inches) 100% Max Boom Length
Extend Cylinder Oil Temperature Drop (F°) 50% Max Boom Length
6' each section
Notes:
1. Projected load drift will be lower for boom angles less than 60°, and slightly more for
boom angles greater than 60° in comparison to the values in the graphs provided herein.
2.
Load drift due to thermal contraction of the hydraulic oil can be mistaken for leaking
cylinder seals or faulty holding valves. If leaking seals or faulty holding valves are
suspected, follow the recommended inspection and diagnostic procedures for
correcting the problem.
T300-1_T500-1_T780
Safety
62 P/N 12261-683
REVISED: January 2015
To Next Page
Loading...
