TL260
Maintenance
54 / 187
6
06_Maintenance_en.fm - V 0.1 - 14.4.11
11
Stipulated consumables for use in central Europe
Tab. 6-5 Consumables
Application Designation Specification, stan-
dards, quality
Remarks
Engine Diesel fuel EN 590
ASTM D975 1-D/2-D
Before using RME-fuels ask your Terex
dealer for further details.
Engine Engine oil SAE 15W-40
API CH4 or CI4
ACEA E3 or E4
See also engine manufacturer's operating
manual.
Cooling for
engine
Coolant Antifreeze based on
ethylene glycol
See also engine manufacturer's operating
manual.
Hydraulic
system
Hydraulic oil or
multi-grade
engine oil
HVLP 46 or
SAE 10W-40
The following viscosity limit values must be
observed (according to ASTM 445):
at 100°C min. 8 mm
2
/s (cSt)
at -10°C approx. 1,500 mm
2
/s (cSt)
Bio-degradable
hydraulic oil
based on
synthetic ester
Filling according to
customer specifications.
Brand label on machine.
The same viscosity values apply as for
mineral hydraulic oils.
Gear unit ATF-oil ATF
Type A Suffix A
Dexron-IID
Alternative recommendations
Dexron-III F, -III G, -III H
Axles, wheel
hubs
Differential
Transmission oil SAE 85W-90LS
API-GL 5
Alternative recommendations
SAE 90LS
SAE 80W-90LS
Lubricating
points
Multi-purpose,
lithium-soap
based grease
K2K-30
DIN 51825
Cooler Mixture of water,
additives and
glycol
The antifreeze is factory-set to approx. -25
°C.
To Next Page
