7 Maintaining the product
137
13. Click on [Next >].
- If a router is connected at the Saveris base the configuration of
the connection type for the probes is shown.
If you have not registered a router, continue with step 17.
14. Click in the Connection type cell of the probe to be assigned to
a router.
- The cell is shown as a selection list.
15. Use button to open the selection list and select the router to
which the probe should be assigned.
16. Perform steps 14 and 15 for any other probes with
measurement data to be transmitted to the Saveris base via a
router.
17. Click on [Next >].
- The wizard is displayed with the start of measurement
configuration.
To Next Page
Loading...
