TESTO Saveris Instruction Manual

7 Using the product
49
Showing regression curve
Place a regression curve over the diagram to show the course that the
measurement series tends to take.
1
Click on Edit | Tools | Regression curve.
2
Click on the reading curve for which the regression curve needs to be
shown.

The regression curve is shown and its regression coefficients are
displayed in the status bar.
If you click on the curve again, the regression curve is once more
hidden.
Characteristics of a curve
You can adapt the display of a measurement series to your requirements. So,
you can for example change the line width of a curve or the representation of
the limit values in the diagram.
1
Switch to the diagram view of the measurement series whose
characteristics need to be displayed.
2
In the Edit | Lines menu, click on the entry of a curve whose
characteristics need to be displayed.

The Characteristics of (curve name) dialogue is opened.
The following tabs are available in the dialogue:
• Edit line tab
• Range limits tab
• Statistical computation tab
Buttons of the dialogue
Button Explanation
[OK]
Applies the changed settings. The
dialogue is closed.
[Cancel]
Closes the dialogue without applying
the changes.

TESTO Saveris Specifications

General

Humidity Range	0 to 100 %RH
Measurement Parameters	Temperature, Humidity
Data Transmission	Wireless
Alarm Function	Yes
Resolution	0.1 °C, 0.1 %RH
Radio Frequency	868 MHz, 915 MHz
Data Storage	Internal memory, Cloud
Power Supply	Battery