Textron Stampede 900 2017 - Information Display Removal; Engine Control Unit (ECU)

B
ELECTRICAL SYSTEM
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
139
Repair and Service Manual
668061
Information Display Removal
Fig. 6 Information Display
Tool List Qty.
Ratchet........................................................................ 1
Torx Bit, T30 ................................................................ 1
1. Disconnect the harness from the back of the infor-
mation display (16).
2. Remove screws (17) that secure the information dis-
play to the instrument panel (Ref. Fig. 6).
3. Installation is the reverse order of removal.
Engine Control Unit (ECU)
Fig. 7 Engine Control Unit (ECU)
Tool List Qty.
Ratchet........................................................................ 1
Torx Bit, T30 ................................................................ 1
1. Disconnect the harness from the bottom of the
engine control unit (ECU) (1).
2. Remove th bolts (3) and nuts (2) that secure the
ECU to the rear of the engine bay closeout panel
(Ref. Fig. 7). Remove the ECU.
3. Installation is the reverse order of removal.
Front of Vehicle
16
17
Instrument Panel
Front of Vehicle
Engine Bay
Closeout
1
3
2