13DHB MPE850 UTV Rev A | 409135 |
5 Troubleshooting with trouble codes
5.2 Description of trouble codes
5.2 Description of trouble codes
Trouble code
Displayed fault
Trouble code description
Possible consequences
Affected part/system
► Possible consequences/remedy
P0011 Camshaft Position not Valid
Invalid signal at the sensor camshaft.
Sensor camshaft
► Check the valve timing. (See the vehicle
manufacturer‘s documentation.)
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0016 Crankshaft Position – Camshaft Position
Correlation - Synchronisation Loss
The signals sensor crankshaft and sensor
camshaft are not synchronous.
Rough engine running.
Engine does not start or stalls.
Sensor crankshaft
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
► Check the crankshaft reluctor. (See
chapter 6 Test procedures at engine.)
P0018 Camshaft Position Spike Detected
Additional signal at the sensor camshaft.
Loss of power.
Sensor camshaft
► Check valve springs and rocker arms.
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0030 HO2S Heater Control Circuit Open Sensor 1
Open circuit at part or wire harness.
Loss of power.
Rough engine running.
Sensor lambda 1
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
To Next Page
Loading...
