Textron Stampede 900 2017 - Hand Hold Removal; Front Shock Tower Brace Removal; Rear Shock Tower Brace Removal

B
FRAME
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
33
Repair and Service Manual
668061
2. Remove bolts (6) that secure the inner legs of the
support to the frame.
3. Remove the dash support from the frame.
4. Installation is in the reverse order of removal.
5. Tighten hardware to the torque specified below:
Hand Hold Removal
1. Release and remove the pins (4) that secure the
handhold (2) into the dash support. (See Fig. 3)
2. Pull the hand hold out of the dash support tubes.
3. Installation is the reverse order of removal.
Front Shock Tower Brace Removal
Fig. 4 Shock Tower Brace
Tool List Qty.
Ratchet........................................................................ 1
Socket, 13mm ............................................................. 1
Socket, 17mm ............................................................. 1
Wrench,13mm ............................................................. 1
Wrench, 17mm ............................................................ 1
Torque Wrench, ft. lbs. ................................................ 1
1. Remove the bolts (8) that secure the front shock
tower brace (7) to the frame (1) (Ref. Fig. 4).
Remove the brace.
2. Installation is in the reverse order of removal.
3. Tighten hardware to the torque specified below:
Rear Shock Tower Brace Removal
Fig. 5 Rear Shock Tower Brace
ITEM NO TORQUE SPECIFICATION
6
15 - 18 ft.lbs. (20 - 24 Nm)
31
15 - 18 ft.lbs. (20 - 24 Nm)
1
78
8
Front of Vehicle
ITEM NO TORQUE SPECIFICATION
8
15 - 18 ft.lbs. (20 - 24 Nm)
Front of Vehicle
32
1
FOR VEHICLES
MANUFACTURED
BEFORE MARCH 13, 2017
38
38
FOR VEHICLES
MANUFACTURED
AFTER MARCH 13, 2017
32
38
1
Front of Vehicle