B
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
23
Repair and Service Manual
668061
Striker Plate Removal
Fig. 10 Striker Plate
Tool List Qty.
Socket, 7/16” ............................................................... 1
Ratchet........................................................................ 1
Wrench, 7/16”.............................................................. 1
Torque Wrench, ft. lbs. ................................................ 1
1. Remove the bolts (42) and nuts (43) that secure the
striker plate (41) to the ROPS tube (See Fig. 10).
2. Installation is the reverse order of removal.
3. Adjust the position of the striker plate or door as
needed after installation to allow the doors to latch
properly.
4. Tighten the hardware to the torque specified below:
Floorboards
Fig. 11 Floorboards
Tool List Qty.
Screwdriver, Flat Tip ....................................................1
Torx Bit, T30.................................................................1
Ratchet ........................................................................1
1. Remove the rocker panel. See Rocker Panel
Removal on page 20.
2. Remove the plastic rivets (11) that secure the cup
holder (5) to the seat closeout and the prop-shaft
cover (4) (See Fig. 11). Remove the cup holder.
3. Remove the screws (6) that secure the prop-shaft
cover (4) to the floorboards. Remove the cover.
4. Remove the screws (9) that secure the floorboards
to the frame.
5. Remove the screws (6) that secure the floorboards
to the bulkhead. Remove the floorboards.
6. Installation is the reverse order of removal.
Item Torque Specification
3, 20, 21 11 - 15 ft. lbs. (15 - 20 Nm)
12 11 - 15 ft. lbs. (15 - 20 Nm)
7 5 - 6 ft. lbs. (7 - 8 Nm)
ITEM NO TORQUE SPECIFICATION
42, 43 15 - 18 ft.lbs. (20 - 25 Nm)
Front of Vehicle
41
42
43
1
9
9
10
10
6
4
4
6
6
5
Bulkhead
Front of Vehicle
Seat Closeout
11
To Next Page
Loading...
