EasyManua.ls Logo

Textron Stampede 900 2017 - Rocker Panel Removal; Side Panel and Rear Fender Liner Removal; Quarter Panel and Front Fender Liner Removal

Textron Stampede 900 2017
237 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
B
20
Repair and Service Manual
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
Rocker Panel Removal
Fig. 5 Rocker Panel
Tool List Qty.
Screwdriver, Flat Tip .................................................... 1
Torx Bit, T30 ................................................................1
Ratchet ........................................................................ 1
1. Remove the two screws (5) that secure the rocker
panel (7) to the frame (See Fig. 5).
2. Remove the two plastic rivets (13) that secure the
rocker panel to the frame. Remove the rocker panel.
3. Installation is the reverse order of removal.
Side Panel and Rear Fender Liner Removal
Fig. 6 Side Panel and Rear Fender Liner
Tool List Qty.
Screwdriver, Flat Tip ....................................................1
Torx Bit, T30.................................................................1
Ratchet.........................................................................1
1. Remove the rocker panel. See Rocker Panel
Removal on page 20.
2. Remove the screw (9) and plastic rivets (13) that
secure the side panel (3) to the frame (See Fig. 6).
Remove the side panel.
3. Remove the screws (9) that secure the rear fender
liner (5) to the frame. Remove the rear fender liner.
4. Installation is the reverse order of removal.
Quarter Panel and Front Fender Liner
Removal
Tool List Qty.
Screwdriver, Flat Tip ....................................................1
Torx Bit, T30.................................................................1
Ratchet.........................................................................1
1. Remove the rocker panel. See Rocker Panel
Removal on page 20.
2. Remove the door. See Door Removal on page 21.
3. Remove the plastic rivets (13) and screw (9) that
secure the front fender liner (11) to the quarter panel
(1) (See Fig. 7). Remove the front fender liner.
4. Remove the plastic rivets (14) and screws (10) that
secure the quarter panel to the frame. Remove the
quarter panel
Front of Vehicle
5
13
7
13
9
3
5
9
Front of Vehicle

Table of Contents

Related product manuals