Textron Stampede 900 2017 - Premium Brush Guard Removal

B
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
19
Repair and Service Manual
668061
Premium Brush Guard Removal
Fig. 4 Premium Brush Guard
Tool List Qty.
Ratchet ........................................................................ 1
Socket, 17mm.............................................................. 1
Wrench, 17mm ............................................................ 1
Torque Wrench, ft. lbs.................................................. 1
1. Remove the two bolts (20) that secure the upper
shield (11) to the shield mounting bracket (16) (See
Fig. 4).
2. Remove the four bolts (21) that secure the upper
shield (11) to the lower shield (12). Remove the
upper shield (11).
3. The grill (14) can be removed from the upper shield
by removing two plastic rivets (15).
4. Remove the two bolts (22) that secure the lower
shield (12) to the frame. Remove the lower shield
(12).
5. Remove the bolts (3) and nuts (4) that secure the
brush guard (1) to the bracket (2).
6. Remove the bolts (3) and nuts (4) that secure the
brush guard (1) to the frame.
7. Remove the brush guard.
8. Installation is the reverse order of removal.
9. Tighten the hardware to torque specified below.
1
11
21
14
15
12
3
3
3
3
4
3
4
4
4
6
22
3
20
Front of Vehicle
2
16
Item Torque Specification
3, 20, 21, 22 30 - 33 ft. lbs. (40 - 45 Nm)