Textron Stampede 900 2017 - Door Handle and Latch Assembly Removal

B
22
Repair and Service Manual
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
Door Handle and Latch Assembly Removal
Fig. 9 Door Handle and Latch Assembly
Tool List Qty.
Ratchet ........................................................................ 1
Torx Bit, T30 ................................................................1
Torx Bit, T27 ................................................................1
Socket, 15mm.............................................................. 1
Wrench, 15mm ............................................................ 1
Torque Wrench, ft. lbs.................................................. 1
1. Remove the screws (20) that secure the cover plate
(1) to the door (See Fig. 9).
2. Remove the screws (12) that secure the cover plate
(1) to the latch mount bracket (10) and to the door.
3. Remove the door handle assembly.
4. Remove the screws (3) and nuts (21) that secure the
cover plate to the door lever assembly.
5. Remove the screws (7) that secure the latch mecha-
nism to the latch mount bracket (10).
6. The push rod (25) can be removed by twisting the
clips (26) to the open position.
7. Installation is the reverse order of removal.
8. Tighten the hardware to torque specified below.
Door
Front of Vehicle
1
20
21
12
12
19
19
5
7
15
24
25
26
26
10
3