Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
49
Repair and Service Manual
668061
WEATHER PROTECTION
GENERAL
The canopy does not provide pro-
tection from falling objects.
The windshield does not provide protection from
tree limbs or flying objects.
The canopy and windshield are designed for weather
protection only.
Clean with water and a clean cloth. Minor scratches can
be removed with a commercial plastic polish or Plexus
plastic cleaner available from the service parts depart-
ment.
CANOPY
Tool List Qty.
Deep Well Socket, 15 mm ...........................................1
Wrench, 15 mm ...........................................................1
Torx Bit, T27.................................................................1
Socket Extension.........................................................1
Hex Bit, 6 mm ..............................................................1
Torque Wrench, ft. lbs..................................................1
Ratchet ........................................................................1
Installing Mounting Brackets
Fig. 1
1. Loosen the ROPS (Roll Over Protection System)
hardware at each of the four upper corner brackets
(Ref. Fig. 1). Do not remove the bolts completely.
2. Slide the passenger side front canopy mounting
bracket (5) underneath the bolt heads at the front
passenger side of the ROPS.
3. Finger tighten the hardware to allow for adjustment.
4. Repeat the above step to install the other three
mounting brackets (4, 6, 7) to the corresponding
ROPS brackets on the front driver side, rear driver
side, and rear passenger side ROPS brackets.
Loosen existing
hardware to
allow room for
canopy bracket.
Front of Vehicle
5
To Next Page
Loading...
