Operation
Instrument Controls Menu
3-48 Model 42i Low Source Instruction Manual Thermo Electron Corporation
IP Address The IP Address screen is used to edit the IP address.
• In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > IP Address.
• Use , , and to move and change the value of
the IP address.
•Press to save the new address.
Netmask The Netmask screen is used to edit the netmask address.
• In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Netmask.
• Use , , and to move and change the value of
the netmask.
•Press to save the new address.
DHCP:
CURRENTLY: OFF
SET TO: ON ?
TOGGLE VALUE
CYCLE POWER TO CHANGE DHCP
RANGE AVG DIAGS ALARM
IP ADDRESS:
CURRENT: 192.168.1.15
SET TO: 192.168.1.15 1
§¨
MOVE CURSOR
©ª
CHANGE VALUE
SAVE
RANGE AVG DIAGS ALARM
To Next Page
Loading...
